Half-Inch Schraub-Befestigung mit Gewindebohrung (Schrauben nur von oben)
CD4 tauglich (Quadro)
Nein
Besonderheiten
SPECIFICATIONS FOR KLEOS MONO • Designer: Jonathan Carr • Builder: Yoshinori Mishima (final build, testing), Akiko Ishiyama (preliminary build) • Type: Medium weight, medium compliance, low-impedance, low-output moving coil cartridge • Stylus: Lyra-designed long-footprint variable-radius line-contact nude diamond (3um x 70um profile, block dimensions 0.08 x 0.12 x 0.5mm), slot-mounted • Cantilever system: Solid boron rod with short one-point wire suspension, directly mounted into cartridge body • Coils: Two individually isolated monophonic/monaural 6N high-purity copper coils wound in parallel (on top of each other) on a square-shaped chemically-purified high-purity iron former with 3.0 ohms self-impedance • Output voltage: 0.25mV@5cm/sec., 2.4μH inductance • Frequency range: 10Hz ~ 50kHz • Compliance: Approx. 12x10-6cm/dyne at 100Hz • Vertical tracking angle: 20 degrees • Cartridge body: One-piece machining from solid 7075 alloy billet, with reduced-surface higher-pressure headshell contact area, partially non-parallel shaping, phase-interference resonance-controlling mechanism, and body threaded directly for mounting screws • Cartridge mounting screws: 2.6mm 0.45 pitch JIS standard • Distance from mounting holes to stylus tip: 9.5mm • Cartridge weight (without stylus cover): 8.8g • Recommended tracking force: 1.65 ~ 1.78g (1.72g recommended) • Recommended load directly into MC phono input: Determine by listening, • Recommended load via step-up transformer: Use a step-up transformer designed for 2 - 3 ohms cartridge impedance. The transformer output must be connected to standard 47kohm MM-level RIAA input, preferably via short, low-capacitance cable • Recommended tonearms: High-quality pivoted or linear tangential tonearms with rigid bearing(s), adjustable anti-skating force, preferably VTA
Gerät vorführbereit
war einige Zeit in der Vorführung, derzeit nicht vorführbereit
